2003 Honda Shadow 1100 Carburetor Assembly: The Carburetors Receive a Rebuild Kit and Reassembled

#hondashadow #motorcyclerepair #carburetor
Greetings to all who found this video on YouTube. The video shows how to install a carburetor rebuild kit in the 2003 Honda Shadow 1100 carburetors. Also, I separated the right and left carburetors in an earlier video, and the carburetors are mated back together in this video. Below are timestamps to help you find a particular moment in the video.
The following time stamps pertain to the right-side carburetor.
1. From 00:00 to 00:17 is the introduction to the video's contents.
2. From 00:18 to 02:44, the carburetor cleaner is sprayed into all air and fuel passages and blown dry using compressed air.
3. From 02:45 to 03:26, the carburetor rebuild kit is opened, and all parts are organized.
4. From 03:27 to 03:58, the main jet seat is installed.
5. From 03:59 to 04:23, the slow jet is installed.
6. From 04:24 to 04:41, the main jet is installed.
7. From 04:42 to 05:28, the needle seat and filter are installed.
8. From 05:29 to 06:26, the float and needle are installed.
9. From 06:27 to 06:55, the float height was checked, and no adjustment was needed.
10. From 06:56 to 09:50, the float bowl gasket and cover are installed.
11. From 09:51 to 12:20, the air cut-off diaphragm, spring, cover, and vacuum elbow are installed.
12. From 12:21 to 15:36, the main vacuum diaphragm, spring, and cover are installed.
13. From 15:37 to 20:37, the carburetor linkage and butterfly are installed.
The following steps pertain to the left-side carburetor.
14. From 20:38 to 22:18, the carburetor cleaner is sprayed into all air and fuel passages and blown dry using compressed air.
15. From 22:19 to 22:30, the carburetor rebuild kit is opened, and all parts are organized.
16. From 22:31 to 23:00, the slow jet is installed.
17. From 23:01 to 23:28, the main jet seat is installed.
18. From 23:29 to 23:52, the main jet is installed.
19. From 23:53 to 24:36, the needle seat and filter are installed.
20. From 24:37 to 25:05, the float and needle are installed.
21. From 25:06 to 26:10, the float level is checked and adjusted.
22. From 26:11 to 28:10, the float bowl gasket and cover are installed.
23. From 28:11 to 30:45, the main vacuum diaphragm, spring, and cover are installed.
24. From 30:46 to 32:36, the air cut-off diaphragm, spring, cover, and vacuum elbow are installed.
25. From 32:37 to 37:00, the carburetor linkage and butterfly are installed.
26. From 37:01 to 37:24, the idle adjustment thumb screw is installed.
27. From 37:25 to 40:23, the right and left carburetor are assembled back together.