Electronic Lead Screw on the Craftsman 101/Atlas 618 6" Lathe

In stead of dealing with gear changes every time you wish to change the feed rate, you just push a button (or two).

This is the implementation of the Clough42 ELS on the Atlas Lathe bringing the 1940s lathe into the 21 century.

Here is more info from James at Clough42    / @clough42  

Here's links to parts I used (some affiliate):
pulleys 2gt 60 theeth https://amzn.to/3LksaTh
pulleys 5.08mm39 Teeth (my motor had 13 teeth present) https://amzn.to/3ovC9x7
pulleys 5.08 40 Teeth https://amzn.to/41BKXAb
pulley 5.08 20 Teeth https://amzn.to/3H294zR
PSU https://amzn.to/3LmH4cJ
plugs https://amzn.to/3Neen2O
belts https://amzn.to/40Cca4h
motor bracket https://amzn.to/3VeuWhr
5V power https://amzn.to/3KZ40NN
case controller https://amzn.to/3AnjaaK
Electronics case https://www.homedepot.com/p/Safety-Te...
Clough42 kit https://www.ebay.com/itm/164781208092
encoder https://www.ebay.com/itm/303247814222
MDrive23 Look on ebay or use any other Nema23 Stepper with Driver/Servo
Ti Launchxl-F280049C https://www.digikey.com/en/products/d...

Here's a link to Clough42's ELS wiki with its own BOM https://github.com/clough42/electroni...