How To Replace Broken Glass Apple SmartWacth Series 3

How To Replace Broken Glass Apple SmartWacth Series 3
Has your Apple Watch Series 3 taken a tumble and cracked the display? Don’t panic! While the glass on the Apple Watch is durable, it can break under impact. Replacing the broken glass may seem daunting, but with the right tools and careful steps, it’s possible to do it yourself—saving you time and money compared to official repair services.

This repair involves disassembling your Apple Watch and may void your warranty. Proceed at your own risk. If your device is under warranty or AppleCare+, consider contacting Apple Support first.

---

🔧 *What You’ll Need:*
Replacement OLED display with glass (compatible with Apple Watch Series 3)
Pentalobe screwdriver (P2)
Phillips #000 screwdriver
Plastic pry tools or spudger
Suction cup (mini)
Tweezers
Heat gun or hair dryer
Adhesive strips or display adhesive
Clean workspace with good lighting

---

🛠️ *Step-by-Step Replacement Guide:*

*1. Power Off Your Apple Watch*
Hold the side button and slide to power off to avoid short circuits.

*2. Remove the Pentalobe Screws*
Use a P2 pentalobe screwdriver to remove the two screws at the bottom of the watch. Keep them safe.

*3. Apply Heat to Loosen Adhesive*
Use a heat gun or hair dryer around the edges of the display for 1–2 minutes to soften the strong adhesive.

*4. Lift the Display*
Place a mini suction cup near the Digital Crown. Gently pull upward while inserting a plastic pry tool to separate the screen from the case. Work slowly around the edges.

*5. Disconnect the Display*
Once the screen is lifted (~90 degrees), locate the three delicate display connectors on the logic board. Use a spudger or tweezers to gently disconnect them.

*6. Remove the Old Display*
Carefully lift the broken display out and set it aside.

*7. Transfer Components (If Needed)*
On Series 3, some sensors (like the heart rate module) are integrated into the display. If your replacement is a full assembly, this step may not be needed. Otherwise, transfer necessary components with extreme care.

*8. Install the New Display*
Position the new display and reconnect the three ribbon cables securely. Ensure they are fully seated.

*9. Reattach the Display*
Lower the display into place and press gently around the edges to secure it. Apply new adhesive strips if included.

*10. Replace the Screws*
Screw the two pentalobe screws back in to secure the display.

*11. Power On and Test*
Turn on your Apple Watch. Check the touchscreen, display clarity, brightness, and functionality (buttons, sensors, etc.).

---

✅ *Tips for Success:*
Work on a clean, static-free surface.
Take photos during disassembly to remember cable positions.
Be gentle with ribbon cables—they are fragile!
Consider using a repair jig to hold the watch securely.
🔁 *Final Thoughts*
Replacing the broken glass on an Apple Watch Series 3 is a precise task, but with patience and the right tools, it’s achievable. If you're unsure, professional repair services are a safer option. However, for tech-savvy users, this DIY fix can bring your trusted wearable back to life!

🔧 Always prioritize safety and double-check each step. Happy repairing!