Eclipse Escaneo Fallas Con OBD2 Bluetooth | EdelGarage

Auto escaneo solo disponible para versiones de eclipse 1995-1997 con motor 2.0 sin turbocargador.

-código 12 significa que se ha desconectado la batería en los últimos 50 ciclos de uso, no es una falla.
-código 55 significa fin de autoescaneo, no es una falla.

Code 11..... Intermittent loss of crankshaft and/or camshaft position sensor signals to PCM, complete loss of crankshaft position sensor signal to PCM, or timing belt skipped one or more teeth
Code 13..... Problem with the MAP sensor circuit
Code 14..... MAP sensor voltage out of normal range
Code 15..... A problem with the Vehicle Speed Sensor Signal. No Vehicle speed sensor signal detected during road load conditions.
Code 16..... No input signal from knock sensor.
Code 17..... Engine is cold to long. Engine coolant temp remains below normal operating temp during initial operation (check Thermostat)
Code 21..... Problem with the upstream oxygen sensor signal circuit. Sensor voltage to computer not fluctuating.
Code 22..... Engine coolant temp sensor voltage out of normal range
Code 24..... Throttle position sensor voltage high or low. Test the Throttle position sensor.
Code 25..... Idle Air Control (IAC) motor circuits. A shorted condition is detected in one or more of the IAC motor circuits.
Code 27..... One of the Injector control circuit output drivers does not respond properly to the control signal. Check the Circuits.
Code 31..... EVAP system fault.
Code 32..... An open or shorted condition detected int he EGR solenoid circuit. Possible air/fule ratio imbalanc not detected during diagnosis.
Code 35..... Open or shorted condition detected in the radiator fan high or low speed relay circuits
Code 36..... Pulsed secondary air injection system problem (95 manual transaxle only)
Code 37..... Transaxle PARK?NEUTRAL switch failure
Code 42..... Fuel pump relay of MFI (ASD) relay control circuit indicates an open or shorted circuit conditon.
Code 43..... Misfire on one or more cylinders detected. Spark plug, injector, cylinder compression or air intake problem; primary circuit problem in one or both ignition coils
Code 45.....Transaxle fault present in transmission control module - Automatic transaxles
Code 46..... Charging system voltage too high. Computer indicates that the battery voltage is not properly regulated
Code 47.....Charging system voltage too low. Batter voltage sensor input below target charging voltage during engine operation and no significant change in voltage detected during active test of alternator output.
Code 51..... Oxygen sensor signal input indicates lean fuel/air ratio condition during engine operation.
Code 52..... Oxygen sensor signal input indicates rich fuel/air ratio condition during engine operation.
Code 53..... Internal PCM failure detected
Code 54..... No camshaft position sensor signal. Problem with the sensor or circuit.
Code 62..... Unsuccessful attempt to update EMR mileage in the PCM EEPROM. PCM failure
Code 63..... Controller failure. EEPROM write denied. Check the PCM
Code 64..... Catalytic converter efficiency below required level
Code 65..... Power Sterring switch failure detected
Code 66..... Transmission control module (TCM) not sensed by PCM.


suscribete y activa la campanita para recibir notificaciónes cuando suba nuevos videos !

Correo Electrónico: trakaretos@gmail.com