How To Make A DIY Engine Run Stand For a Small Block Mopar

I walk you through how I built my engine run stand out of scrap fence wood from behind my outbuilding. Many of you have asked about it so here it is! This is built to support a Small Block MOPAR but I am sure you can adapt it for other engines if you need to. If you found this useful let me know down in the comments!

PDF Instructions: https://drive.google.com/file/d/1oFeN...

(00:00) Introduction: The video shows how to build a DIY engine run stand for a Small Block Mopar engine, with a downloadable PDF containing materials and step-by-step instructions.
(00:30) Tools needed: Impact driver, drill, various screws (3-inch wood screws, 5.5-inch structural screws), and lag bolts. The tools you use will depend on your hardware.
(01:09) Initial assembly: Begin with 26-inch 4x4s and five 28-inch 2x4s. Attach the 2x4s to the 4x4s using screws, ensuring the frame is square.
(02:56) Adding casters: Attach two fixed and two swivel casters to the base for mobility. Fixed casters go at the rear, and swivel ones at the front for ease of maneuvering.
(04:07) Attach supports: Install 28-inch 2x4s as top supports and brace with screws. Measure and mark for engine mounts, then attach using screws.
(05:36) Motor mounts: Attach motor mounts 5-16 inches from the ends using screws. Cross braces are added for stability.
(06:20) Final frame adjustments: Install a cross brace to support the structure, and ensure everything is squared and aligned.
(07:50) Rad support: Install radiator supports, making adjustments for fan clearance. Additional spacers are used for better support.
(09:26) Control setup: Mount a control panel using leftover materials for a 12V toggle switch, push button, and gauge pod (water temperature, oil pressure, tachometer).
(10:29) Conclusion: The stand is complete, with a final note on adding a transmission support. For further details on wiring, a separate video is referenced.