#1 Johnson Outboard Lower Unit Crack Repair/Rebuild

This boat was in winter storage in a Wisconsin garage and the oil was never checked for water prior to winter setting in. The result was a cracked lower unit case the water that was in the lower unit froze and broke the case. Depending on where the break is in the case will determine to what extent, and if the case can be repaired. This repair does not run through the oil/water sealing area but is very close, though it does run into the snap ring area, I will not have to weld inside the case on this unit, but I will carefully polish the sealing area for the new o-ring to seal, this repair was very doable. You just have to take your time be careful, and think about what you’re doing before doing it, if it doesn’t feel right stop and think it through. Bottom line is a new lower unit case is not cheap, some models are no longer available, and I know a few people who have bought rebuilt aftermarket lower units and have had many problems with them. I cover all the steps without any sped up sections so the videos may seem long but everything is covered. I completed this work in the spring of 2016. Video #1 of the Johnson GT 150 lower unit crack repair/rebuild is on identification of the needed repair, removing the shift rod bolt, draining the lower unit, and removal of the lower unit. Some of what you will see done in this series of videos will be questionable to many, this is the second lower unit I have repaired in this same fashion, and both went on for many more years of service, and saved the owners in the $1000.00 range, if you attempt this I cannot stress enough do not force anything, take your time. You will need to buy the parts for the rebuild, all seals gaskets water pump etc will need to be replaced so you will have to locate and identify the model and serial numbers of your specific outboard. After you have that information you will need to search the best parts outlet (if you can buy the original manufacturer part)/tutorial videos, and exploded view diagrams, the link below is a good website for information and tooling as you will also have to purchase some tools to complete the task.
http://www.sterndrive.info/outboardmo...