New High Voltage wiring for my Skutt kiln rebuild ⚡️

In this video I start wiring the high voltage side of the skutt kiln I'm rebuilding. First I mount the thermocouple which will be used to read the temperature for a digital controller. Then I use high temperature wire and crimp on connectors to wire the existing thermocouples. The two elements in one ring are wired in parallel like a modern Scutt 1018 kiln. The high temperature wire is then connected with a spade terminal to two relays, one for each section. Next the relays are attached to a terminal block for the 240 volts needed using short pigtails. Finally I attach the cord to the terminal block and the ground wire.

TOOLS & MATERIALS (affiliate)
Replacement 50 amp power cord https://amzn.to/2Y8i9DD
Terminal Block https://amzn.to/3jriDNt
Skutt relay, Potter & Brumfield T92P7D22-12 12v, 30a https://amzn.to/3ypOGkP
High temperature spade connector (for relay) https://amzn.to/3sUPkWu
High temperature ring connector (for terminal block and elements) https://amzn.to/3Bm0NBt
High temperature ferrules for elements https://amzn.to/3mMTi2m
High temperature wire https://amzn.to/2WsJ7FH
Skutt K type thermocouple https://amzn.to/3mJV0Bu