Ford Heated Windscreen Not Working NOW FIXED! Unbelievable!

In this video, I show you how I fixed my heated front screen on my 17 plate ford focus. Unbelievable

Please say thanks in the comments.. (Or bad karma)

Here's a link to part 1 where I show how to check fuses.    • Ford Heated Windscreen Not Working Fuse Ch...  

Here's a link to the fuses. https://geni.us/6jF7sqX (paid link) As an Amazon Associate, I earn from qualifying purchases

Here's a link to the ford forum that shows how to do the repair
https://passionford.com/forum/technic...

Here's a vid on removing the Scuttle to access the ribbon
   • HOW TO REMOVE AND REPLACE WINDSHIELD COWL ...  

Here's a vid showing the ribbon locations

   • Ford Focus 56 plate heated windscreen (cor...  

Here are the instructions for replacing the ribbon

1. Open bonnet
2. Remove rubber covers on window wipers. Expose nuts
3. Using a set of grips or spanner undo bolts
4. THE WINDOW WIPERS.
To remove the wipers, push down on the join and pull the wiper arm towards the engine bay and lift up. x2
5. You will see around about 8 clips holding on the plastic trim that the wiper supports come through. Remove these clips
6. Remove plastic trim, this just peels off.
7. Now you have exposed the window wiper bars and heating elements.
Take a look on the driver side and you will see a cable hanging loose and a black tab hanging from under your window.
8. Disconnect cable and cut open the opposite end to expose the cable inside. You will see small square of treated copper.
9 scrape off the silver to expose copper.
10. Get some 2.5mm stranded cable around 10 inches is enough. strip 10mm of insulation away and using a solder iron tin the end fully. Heat shrink can be added to this cable.
11. Tin with solder the exposed copper on the small square of copper.
12. If you can clamp these 2 cables together while you solder then do so as it can be tricky. If not get someone to help you.