Autonomous Crawler: DIY Aluminum battery-holder for you RC car

This video shows how I made an aluminum battery holder for a LIPO used for powering the computer in my autonomous crawler. It is shaped in a way to hopefully prevent too much damage to the computer in case of LIPO explosion.

I bought myself a software for video editing and wanted to give a go on trying something different this time.

What you need for making this battery holder is:
1.5mm thick aluminum sheet... size depends on your battery
straight angle, pencil to draw lines on aluminum
a drill and drill bits, screws and nuts
metal files
tin snips for cutting the sheet aluminum
2 clamps and a rigid/straight piece of metal for bending the aluminum on a table or a sheet metal bender
solvent for cleaning the bare metal surfaces
spray primer and paint
straps for holding the battery in place
glue backed soft foam/rubber for cushioning the LIPO against the aluminum surface.
Hint 1: When drawing the outlines of the folds on aluminum sheet... leave a bit extra space for the battery on all sides and also for the softening.
Hint 2: Plan carefully how you will fold the sides of the holder.. depends very much on your available tools and holder size.

Songs in this video are from YouTube audio library as follows:
Bottle of Something -- TrackTribe
Take your Time -- Dan Lebowitz
Come with Us -- Nat Keefe & Hot Buttered Rum
Casey Don't you Fret -- Dan Lebowitz