Bixler 2 Radio Controlled Sailplane Unboxing and Setup

With no instructions in the box, Jim works through what's needed to put this RC plane together and get it going. Much detail is given, so you can use the contents below to pop quickly to the sections that you need to refer to as you use this video for your own set of instructions!
Contents:
00:00 Bixler2 unboxing
00:50 Unpacking the box
03:36 Fastening wings
07:40 Horizontal stabilizer
08:05 Vertical stabilizer
09:00 Optional flaps
10:34 Gluing tail surfaces
12:18 Flap cutting
13:52 Flap control horns
14:40 Removing wings
15:05 Postion of flap servo
15:20 Using servo tester
16:20 Mounting control horn
19:00 Fitting flap servo
19:40 Fitting panel over servo leads
22:18 Cutting flaps
23:50 Fitting flap control rods
25:42 Need for gluing entire panel
27:25 Gluing panel
28:45 Issue with flap servos
30:30 Plan for mixing flap servos
31:00 Preparing left wing
42:25 Battery: 3S 2200 mAH
48:17 Servo harness and extensions
51:00 Servo tester on flaps
53:00 Re-installing wings
59:30 Receiver & ESC positions
1:02:40 Sorting out servos
1:05:27 Prop components
1:06:38 Transmitter settings
1:07:48 Balancing
1:12:40 Sorting cables
1:13:40 Locating battery
1:14:02 Testing Amps
1:17:00 Maiden flight report