Make A Curve Tracer For Your Lab - Part 4: Level Adjustment

Fourth part of the design and construction of a curve tracer.
In this video we will work on the level adjustment, the block capable of changing the polarity of the ladder and the ramp signals, as well as changing their amplitude.

Khaled Magdy web page on ATMega328 registers:
https://deepbluembedded.com/arduino-p...

Companion WEB site with all the documentation to build your own curve tracer:
https://eleneasy.com/make-a-curve-tra...

Chapters:
00:00 Introduction
00:42 Schematic
03:18 Prototype
04:30 Testing
05:36 Conclusion


Subscribe to the channel to receive notifications for every new video I publish, so you can follow all the episodes related to this project. And, please, don't forget to give me a thumb up!

Please support the channel by donating through one of the following links:

one time donations: https://paypal.me/eleneasy
monthly donations:   / eleneasy  

Also:

Check out my website eleneasy.com, where I publish related articles:
https://eleneasy.com/

and my dazzlingsolutions.com web site, where I post blogs related to networking, software, IT and electronics in general:
http://dazzlingsolutions.com/

I also have a presence on:

X: https://x.com/eleneasy1/
Facebook: https://www.facebook.com/crcarrano/?m...
LinkedIn:   / carlo-carrano-32ab7653  
Pinterest:   / crcarrano  
Quora: https://www.quora.com/profile/Carlo-C...
Instagram:   / eleneasy_i  

Thank you for watching!