Yost Vise Restoration & New Handle
Автор: PatonHaus
Загружено: 2018-04-04
Просмотров: 48493
In this video I restore an old Yost model 104 smooth jaw vise. I began by tearing it down and cleaning most of the crud with varsol, then stripped all of the old paint off. A few drill holes were repaired with weld and ground back smooth. Some wire wheeling and further cleaning was needed before applying a new coat of light grey paint. I also fabricated a new handle with my lathe, using the original handle ball-ends, which were re-welded and ground back smooth. Everything was re-assembled after paint and lightly greased.
Stuff you'll need to restore a vise...
Mig Welder: https://amzn.to/2KhL2AP
Metal Lathe: https://amzn.to/2KN5Rpc
Bench Grinder: https://amzn.to/2rtIEA1
Paint Stipper: https://amzn.to/2Ks19xA
Grey Paint: https://amzn.to/2KtXQoJ
Wire brush (die grinder attachment): https://amzn.to/2JObjGL
Grease: https://amzn.to/2rhTMPG
Hacksaw: https://amzn.to/2FEJHBB
Nitrile gloves - https://amzn.to/2kFq8Bc
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке:
