Lug pattern change tool over view
Автор: thetriode
Загружено: 2020-05-03
Просмотров: 8683
I'm not quite done with it at this point but I need to add a third standoff for drilling the final size. I had trouble finding anyone to convert my 9 inch axles to a 5X5 lug pattern. I decided I would make my own jig to do it therefore this is what I came up with. It's the center of a brake rotor (I think is from a Jeep) that I took some 80 grit sand paper to in order to enlarge the center hole. This lets it fit on the hub of the 9" axle shaft. I then took a wheel stud and bored a hole in it with the lathe, turned it down a bit so that everything was centered where it went in the hole and welded it in. I then made a 9/16 spacer and welded it on as well. I still need to make one for the final size so I can use 5/8 wheel studs. After that I'm going to use these with LTD-II drums, mount some hubcentric rings and call it done. Will it work? Only time will tell.
If you don't have to sweat the axle retainer hole (e.g. doing this on an 8.8) I would probably just make new holes between the old ones. In my case I had to weld up the existing holes and then drill new ones.
I would consider cobalt bits a requirement. Axle steel is tough as is the welding I did to fill the holes on these.
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке:
![Whiskey Blues Music -BEST OLD SCHOOL BLUES MUSIC ALL TIME - Beautiful Relaxing Blues Songs [ Album ]](https://ricktube.ru/thumbnail/dRA19AKYOfs/mqdefault.jpg)
