Популярное

Музыка Кино и Анимация Автомобили Животные Спорт Путешествия Игры Юмор

Интересные видео

2025 Сериалы Трейлеры Новости Как сделать Видеоуроки Diy своими руками

Топ запросов

смотреть а4 schoolboy runaway турецкий сериал смотреть мультфильмы эдисон
dTub
Скачать

Fix Yamaha Waverunner VX deluxe Overheating - New Cylinder head and gasket installation

Автор: Rene Clausen

Загружено: 2024-01-27

Просмотров: 7470

Описание:

Tech Tuesday, this time is back with tech tips on jet skis.

Disclaimer: Slight mechanically skills will be required and necessary to do this job properly.

Extensive video on a Yamaha VX 110 Deluxe, with a problem of running Hot/Overheating after a few minutes of use on the water. The jetski runs totally normal in idle and during freshwater flushing, but cannot go full power for long before activating the temperature sensor/overheating.

Avoid falling into this trap when you buy a jetski, it will show normal operation in a driveway, but NOT on the water.

Main problem is most likely, that the ski was operated in salty waters near coastlines with waves creating sand and saltwater mixture ingestion throughout the engine, which in turn clogs up the cooling canals inside the engine (cylinder, Anode, head, exhaust manifold). This result in normal operation at low power settings with no noticeable problem, but the engine will struggle for deteriorated cooling when forced to give power. Depending on the amount of clogging the warning light will come on at lower or higher settings.

Here is a how to, DIY on trouble shooting and fixing/changing your head gasket, cams and head on your Yamaha VX Deluxe or equivalent.

I used a new Head delivered from SBT, and it works just perfect. Buy a new set of gaskets on Amazon and you are ready.

As promised in the video, here is a link to the service manual, with all tech specs and torque values on your jetski Yamaha VX deluxe 110/1100

https://dokumen.tips/documents/servic...

Symptoms could also be:

Jetski is overheating, only when under load and everything is normal otherwise. Meaning you can flush it and run idle and no overheat warning is coming on. The minute you give power and sail for a little distance approximately 700 yards, the jetski overheat and goes into limb mode.

Here is the possible failure and solution to this problem, and how to solve it.

the jetski used here is a Yamaha VX deluxe, however this could be the case on any jetski out there, which has been in salty, dirty or sandy waters. They simply ingest the salt, sand and dirt and cloggs the coolant system.

enjoy and work slowly towards to finish line. No rush is recommended .


enjoy, and sail safely,

best regards Rene

Fix Yamaha Waverunner VX deluxe Overheating   - New Cylinder head and gasket installation

Поделиться в:

Доступные форматы для скачивания:

Скачать видео mp4

  • Информация по загрузке:

Скачать аудио mp3

Похожие видео

Ремонт двигателя Yamaha Waverunner III 650 Top End

Ремонт двигателя Yamaha Waverunner III 650 Top End

Rusted 6 Cylinder Engine Head: Dead Head Repair and Full Restoration

Rusted 6 Cylinder Engine Head: Dead Head Repair and Full Restoration

2014 Yamaha PWC overheat repair

2014 Yamaha PWC overheat repair

Снятие импеллерного насоса Yamaha SVHO SHO

Снятие импеллерного насоса Yamaha SVHO SHO

Yamaha FX SVHO Complete Engine Tear Down & Rebuild with Cuco Performance + Tech Tips

Yamaha FX SVHO Complete Engine Tear Down & Rebuild with Cuco Performance + Tech Tips

The Ultimate Yamaha Jet Pump Pull

The Ultimate Yamaha Jet Pump Pull

Перегрев выхлопной системы Yamaha Waverunner 2022 года 🔥Пока нет решения

Перегрев выхлопной системы Yamaha Waverunner 2022 года 🔥Пока нет решения

1200 YAMAHA NPV CYLINDER TOP END INSTALL AND CARBURETOR ADJUSTMENTS

1200 YAMAHA NPV CYLINDER TOP END INSTALL AND CARBURETOR ADJUSTMENTS

4.6 Ford How to Replace Head Gaskets

4.6 Ford How to Replace Head Gaskets

Ремонт лодочного двигателя Mercruiser 3.0

Ремонт лодочного двигателя Mercruiser 3.0

Rebuilding the Cylinder Head, New Valves & Springs: Project X S2 E7

Rebuilding the Cylinder Head, New Valves & Springs: Project X S2 E7

How to REPLACE a Head Gasket on a Outboard Motor! (Yamaha 150VMAX)

How to REPLACE a Head Gasket on a Outboard Motor! (Yamaha 150VMAX)

Восстановление корпуса промежуточного вала Yamaha для гидроцикла Superjet Wave blaster

Восстановление корпуса промежуточного вала Yamaha для гидроцикла Superjet Wave blaster

Yamaha VX 1100 — замена масла и фильтра для гидроцикла

Yamaha VX 1100 — замена масла и фильтра для гидроцикла

СНЯТИЕ ДВИГАТЕЛЯ Yamaha Waverunner Rebuild. Запрошен просмотр. Часть 1.

СНЯТИЕ ДВИГАТЕЛЯ Yamaha Waverunner Rebuild. Запрошен просмотр. Часть 1.

YAMAHA 1800 HO 1.8L CAMSHAFT VALVE  TIMING CHAIN INSTALLATION

YAMAHA 1800 HO 1.8L CAMSHAFT VALVE TIMING CHAIN INSTALLATION

Engine Repair Part 3

Engine Repair Part 3

Ford F-150 5.4L SOHC Head Gasket Complete Replacement (Full Length Director's Cut)

Ford F-150 5.4L SOHC Head Gasket Complete Replacement (Full Length Director's Cut)

Гидроцикл Yamaha VX Deluxe перегревается под нагрузкой. Технический вторник.

Гидроцикл Yamaha VX Deluxe перегревается под нагрузкой. Технический вторник.

Fixing A Boat With A 454 Big Block Engine

Fixing A Boat With A 454 Big Block Engine

© 2025 dtub. Все права защищены.



  • Контакты
  • О нас
  • Политика конфиденциальности



Контакты для правообладателей: [email protected]