Wire BAFANG Hub + FLIPSKY 75100 Pro V2! w/ JST SM Crimp Kit

http://buymeacoffee.com/ebikebuilder Code EBB for 10$ off at FLIPSKY.NET! Controller: https://amzn.to/3ArrHgu JST SM Crimp Kit: https://amzn.to/40rEDxl

Wirefy Heat Shrink Bullet Connectors: https://amzn.to/3C7zr7Z (I used 12-10AWG bullet connectors for the phase wires between Flipsky and the L1019 motor cable, they claim amperage of 48A)

Wirefy Crimping tool for Heat Shrink Connectors: https://amzn.to/3NPBy2I

Amass XT90 connectors to terminate leads to battery (need a male XT90 connector for the controller) - https://amzn.to/4f7Omh3

Weller 250W Professional Soldering Gun (i used to solder the XT90 connector) - https://amzn.to/3YE0eQW

If you need a female L1019 motor cable, I chopped mine off an old burned up controller, but you can buy an L1019 motor cable here: https://ebikes.ca/l10-ext.html (I'd buy the extension with both male and female connectors on it, then cut it in half / to length etc, then save the male end of it, and you want the FEMALE end of the L1019 motor cable for the controller!! female side has the holes in it)

I wire a FLIPSKY 75100 PRO V2 controller to a BAFANG RM G062 1000 DC motor, using an L1019 motor cable. I use a JST SM crimping kit to terminate the signal wires. I used 12-10 AWG Wirefy Barrel

I use the VESC TOOL mobile app to configure the Flipsky. It costs a few bucks on iOS, and I believe it's free on Android. There is also VESC TOOL desktop app for computers, but I find the bluetooth is flaky sometimes, I like the mobile app.