Ford Crown Vic rear bumper cover removal install

Need to get your bumper cover off? Perhaps to paint it, patch it, or run wires behind it? I show you how easy, other than the wrestling, that it is to do.

7.5mm clips: https://amzn.to/3BmY0de

8mm clips: https://amzn.to/3BFrjIp

#wjhandydad #crownvic #DIY

0:00 2008 Ford Crown Victoria P71 police interceptor
0:05 retainers in wheel well
0:15 12mm nuts
0:32 underneath bolts or zip ties
1:26 7mm bolts hold on
1:32 plastic retainers
3:06 mine has parking sensors
3:18 8mm retainers
3:29 me griping about the crappy engineering
4:23 one more retainer clip I missed
4:34 removing the cover
5:02 where you should mount parking sensors vs not mount
5:18 Facebook group question answered
5:46 freshly painted and reinstalling
6:30 fishing the parking sensor wires
6:46 wrestling it back on
7:34 edited for television
9:01 panel clips needed


http://www.WJHandyDad.com

Disclaimer:
Due to factors beyond the control of WJ Handy Dad, I cannot guarantee against improper use or unauthorized modifications of this information. WJ Handy Dad assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. WJ Handy Dad recommends safe practices when working on vehicles/homes and or with tools seen or implied in this video. Due to factors beyond the control of WJ Handy Dad, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not WJ Handy Dad.
As an Amazon Associate I earn from qualifying purchases