#128

in this video Power Factor Correction Boost PFC FPAB30BH60 Module function explained in urdu hindi. its pinout, circuit diagram and its working principle. PFC SPM® 3 Series for 1-Phase Boost PFC
Features
• Low Thermal Resistance Thanks to Al2O3-DBC
Substrate
• 600 V - 30 A 1-Phase Boost PFC Including A Drive
IC for Gate Driving and Protection
• Built-In NTC Thermistor for Monitoring Over-
Temperature
• Typical Switching Frequency of 20 kHz
• Isolation Rating of 2500 Vrms/min.
Applications
1-Phase Boost PFC Converter for Air Conditioner
General Description
FPAB30BH60 Is A PFC SPM® 3 Series for 1-Phase Boost PFC (Power Factor Correction) that Fairchild Has Newly Developed for Mid-Power Applications
such as Air Conditioners. It Combines Optimized Circuit Protections and A Drive IC Matched to High Frequency Switching IGBT. The System Reliability
Is Further Enhanced by The Integrated Under-Voltage Lock-Out and Over-Current Protection Function
The detailed features and integrated functions are:
 600 V/20 A and 600 V/30 A ratings in the same package
 Major target of the Boost PFC SPM® 3 series in midpower
air-conditioner applications (1.5~3 kW)
 Compact and cost-effective transfer mold package enable
miniaturization of converter design
 High reliability due to the coordination of fully tested IC
and IGBT
 Integrated full-bridge diode rectifier
 Built-in IC for IGBT gate driving and protection
 Fast-recovery boost diode minimizes reverse-recovery
loss
 Under-Voltage Lockout (UVLO) and Over-Current
Protection (OCP), through an external shunt resistor with
a fault signal output (VFO)
 Built-in thermistor
 Optimized IGBT switching characteristics with reduced
switching loss and low EMI noise
 Low leakage current and high isolation voltage because of
Direct Bonded Copper (DBC)-based substrate
 Active-HIGH input signal logic resolves the startup and
shutdown sequence constraint between VCC (control
supply voltage) and signal input, providing fail-safe
operations. A direct connection between the boost PFC
SPM 3 series and a 3.3 V or 5 V MCU/DSP is possible
without additional external sequence logic.
 Isolation voltage rating of 2000 Vrms for one minute
FPAB30BH60 FPAB20BH60 FPAB60BH60 FPAB40BH60