3D Model Start to Finish using DJI P1 flying RTK, Emlid RX on Emlid Caster Service, and DJI Terra

See bottom for timestamps and index. In this video from DroneMappingTools.com I walk you thru creating a 3D Model with photogrammetry using the DJI P1 Camera (flying RTK), Emlid GNSS Receivers (using the free Emlid Caster Service), and processing in DJI Terra. This same work flow applies to generating an orthomosaic image as well as a 3D model. So if you are new to mapping and modeling with photogrammetry, I will walk you thru the entire process from start to finish.

0:00 Intro
0:10 What we're modeling
1:37 Step 1 Setup the Base
3:13 Setting up a New Project
4:45 Establish base point (using RTK)
8:25 Tip 1 - Marking target corners
9:35 Setting up Base Output for RTK Flight
12:19 Minnie say hello to youtube
12:33 Quick mention on side by side
13:03 Changing Base from RTK to Manual Location
14:52 Connect base to Emlid Caster Service
15:28 Checking Base Settings and Location
17:07 Another quick mention about SxS
18:21 Setting up drone flight
23:40 Figuring out wifi connection problem
27:29 First take off (before losing RTK)
29:29 Second flight fixing camera angle
31:07 Manual low level flight around barn
33:57 Process of Recording GCP 2
36:09 Processing in office intro/overview
37:41 View of model without low level photos
38:27 Start of processing steps
39:55 File naming in DJI Terra
40:14 Adding images to DJI Terra
41:33 Exporting EXIF Data to edit accuracy values
43:52 Editing the Exif data in Excel/ Google sheets
45:59 Importing edited Exif data file
49:07 Importing GCP file
51:34 Marking GCP's in Terra
55:49 Importing KML for Region of Interest
57:53 Reviewing final 3D Model
58:23 Sharing 3D Model online using DJI Modify
59:29 Final Wrap up. Thank you!