Alpha Flight Controls | Yoke Installation | Honeycomb Aeronautical

1. Use the Yoke Connector Cable provided to connect the yoke to the switch panel. You can find the inputs behind the right side of the yoke handle and on the right side of the base near the 5 position ignition switch.

2. Center the yoke above the mounting plate and adjust placement until the yoke is fixed on to the mounting anchor. Slide the yoke back to lock into place. On the rear of the yoke, you will find two screw Locks. Begin to tighten until the screws are embedded within the mounting plate to complete the installation.

3. Connect the USB to the rear of the yoke and then connect to your PC or Mac

4. Use the button on the back to enable the adjustable cockpit lighting with 6 different intensity settings of light.

5. To detach yoke from the mounting plate, unscrew the screw locks on the rear end of the yoke and slide forward to release the yoke off the mounting anchor for detachment.

Dual Mounting Solution:
The Dual Mounting Solution allows for full use with or without clamps. Two heavy-duty clamps made of steel attach and secure the yoke. For thicker tabletops, A large 3M® Micro-Suction Pad that produces 40lbs of tensile strength can be used for a clamp free solution.

Large 3M® Micro-Suction Pad Installation:
Find the desired location you would like to place your yoke. Wipe down and clean the surface area before installation. Remove the plastic covering from the 3M® Micro-Suction Pad and position the mounting plate in the correct orientation. Press down firmly on the entire mounting plate surface until fully secure. To detach, Lift the two detachment levers on the mounting plate to create space between the table surface and the plate. Use the space created to slowly begin lifting the mounting plate off the table until completely detached.

CLEANING:
To clean the Micro-Suction Pad, wash with soap and water using either your hand or a brush to keep tensile strength to its original form. When cleaning, do not use cloth or paper material that will deteriorate as this will be difficult to remove and cause loss of resistance. When the Micro-Suction Pad is not in use, reapply the plastic covering to preserve quality and condition.

For Tech Support please contact us at:
support@flyhoneycomb.com

For more information please visit our website at:
flyhoneycomb.com
Email:
info@flyhoneycomb.com