How To Replace A Broken Stub Axle (TRA2753X) | Traxxas Stampede 2WD

In this video, we will be replacing a broken stub axle on the Traxxas Stampede 2WD.

The tools needed for this replacement are: a 4-way wrench, needle nose pliers, flat head screwdriver, and 2.5mm Allen wrench. The direct replacement part needed for this replacement is TRA2753X.

Begin by removing the wheel on the side of the broken stub axle. Using the flat head screwdriver, pop the wheel hub, or wheel hex, away from the pin on the stub axle. Remove the pin. back the stub axle out of the stub axle carrier, and remove the bearings or bushings on either side. Slide the half shaft out. Using the flat head screwdriver, put the flat head into the opening on the half shaft, just below the u joint. Slide one of the ears on the new stub axle over the top side of the u joint.

Place the 2.5mm Allen wrench between the bottom of the u joint and the flat head screwdriver. Drop the bottom ear of the stub axle over the bottom of the u joint. Slide the half shaft with the stub axle onto the other half shaft. Before pulling the stub axle through the carrier, slide the bearing back onto the axle. Pull the stub axle through the carrier.

Reinstall the outer bushing. Push the pin back into place. Using the needle nose pliers, pop the wheel hex back onto the pin. Reinstall the rear wheel.

If you found this video helpful, please consider liking and subscribing. Until next time, thanks for watching.

DISCLAIMER: The RC Genius YouTube channel displays products and models intended for ages 14 years of age and older. All products shown in the content on this channel are marked as "Not a Toy", and "For Ages 14 & Up". The RC Genius is NOT responsible for persons under the age of 13 who fraudulently claim to be over age 13. The RC Genius acknowledges the COPPA laws and request viewers honor the age requirements.