How To Assemble Piezo PCBMotor on Base Plate PCB

http://tinyurl.com/payuh2s (Download in pdf)
PCBMotor 'How To' video - assembling a Piezo PCB motor onto the base plate print circuit board.
This process is simple and will take only a few minutes to complete.

Procedure
-------------
1. Place the base plate PCB on a flat, stable surface with the center screw facing upwards and put the 4 corner screws in place.
2. Lift the base plate PCB and, with your hand underneath the base plate, place a finger on each of the 4 corner screws to keep them in place when you turn the PCB over.
3. Place the PCB on a flat, stable surface with the screws facing up using a couple of books to leave room for the center screw and to hold the screws in place.
4. Now put washers and spacers on each screw.
5. Gently press the stator with rotors and coupling down onto the screws and contact pins.
a. Make sure that the coupling engages and that the center screw is positioned between maximum and minimum (see Image 1).

6. Check that the stator is aligned with the white stator outline on the base plate PCB (see Image 1 above).
7. Tighten the plastic nuts (and screws at the back with a small screwdriver) and check that the center screw still moves freely (see Image 2, below).

Please share our cool technology - http://ctt.ec/Q8Zqd