SR25 | KAC M110 SASS | AR10 | Polarstar Kythera HPA Build Part 1: Everything is Fine

This is the story of how I went about rebuilding this SR25 from basically scratch.


I found this frame for 50 locally. It was HPA'd but the previous owner put the wolverine into a smaller M4. I decided to rebuild the SR25/AR10/M110 back - first i looked into finding new parts but quickly realized that i'd spend over 200 dollars on rebuilding the gearbox... This is the story of how I went about it.

Subscribe for more! Part 2 already filmed, will be out in a week or two.

Comments, questions, suggestions welcome!
_______________________________________________________________________
Tools Used:


-Hex Bits Set
-3mm for most gearbox screws
-0.05" for the grub screws in the kythera trigger assembly
-Drill Bit 2.5mm
-3mm tapping bit
-Philips screwdriver (a 6" or longer recommended for butt-stock screws)
-Flat head screwdriver
-Dremel and assorted bits (not sure of the names)
-large round sanding (sanding down)
-wire wheel (sanding / polishing)
round cutting wheel (to cut down the spring guide for the hose to fit easily)
-clamps
-heat gun
-Teflon tape
Acetech AC5000 Chronograph
__________________________________________________________________________



________________________
Lofi Hiphop Mix 2021 | Lofi beats to study | No Copyright Lofi Hip Hop 2021
   • Lofi Hiphop Mix 2022 | Lofi beats to study...  
________________________

Song: Rogers & Dean - No Doubt [NCS Release]
Music provided by NoCopyrightSounds
Free Download/Stream: http://ncs.io/NoDoubt
Watch:    • Rogers & Dean - No Doubt | Future Bass | N...