Ford Crown Vic P71 P7B rear shocks replacement

Replaced the rear shock absorbers in my Ford Crown Victoria P71 police interceptor (process should be similar in all Crown Vic models). This is definitely one of the easiest DIY projects. Just need a jack, jack stand, some sockets, pliers, a screwdriver, a torque wrench, and some thread locker.

Monroe 550055 Shocks I used here: http://amzn.to/2CrT3R7

0:00 2008 Ford Crown Victoria police interceptor P71
0:24 switching mine to Monroe 550055 Gas-Magnum 65 towing shocks
0:45 the process for changing shocks (newer Vics are easy)
1:37 prep the new shocks before installation
2:11 jack up the vehicle (tire removal is optional but does make it easier)
2:40 penetrating oil on the top nut makes removal easier
3:05 top nut removal (need to secure the shock so it does not spin)
3:20 lower mounting bolt removal
4:00 old shock easy to remove
4:06 new shock fits in easily


#wjhandydad #crownvic #rearshocks #DIY

http://www.WJHandyDad.com

Disclaimer:
Due to factors beyond the control of WJ Handy Dad, I cannot guarantee against improper use or unauthorized modifications of this information. WJ Handy Dad assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. WJ Handy Dad recommends safe practices when working on vehicles/homes and or with tools seen or implied in this video. Due to factors beyond the control of WJ Handy Dad, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not WJ Handy Dad.
As an Amazon Associate I earn from qualifying purchases