HOW TO INSTALL A ONE PIECE EPDM ROOF - FLEXIPROOF®
Автор: The EPDM Academy by FlexiProof®
Загружено: 2025-03-18
Просмотров: 1238
In this newly updated video tutorial, you’ll learn how to prepare your project site and correctly install a complete, simple EPDM flat roof with the FlexiProof One Piece EPDM flat roof system.
Carefully follow the steps in our video and use the right tools and materials for the very best results.
Contact us with questions or to learn more about our EPDM roofing training: https://www.flexiproof.co.uk/the-epdm...
Learn more about the FlexiProof EPDM flat roof system: https://www.flexiproof.co.uk
00:12 ROOF SURFACE PREPARATION
00:20 Tools required:
• Cordless drill with countersink
• Countersunk screws
• Belt sander
• Leaf blower
00:31 No materials required
00:34 Steps 1 to 4
01:16 MARK THE ROOF PERIMETER AND MEMBRANE FOR CONTACT BONDING ADHESIVE APPLICATION
01:22 Tools required:
• Combination square
• Marker pen
• Heat gun
• Scribe
01:32 Materials required:
• Contact Bonding Adhesive
01:35 Steps 1 and 2
02:20 BONDING THE ONE PIECE MEMBRANE ONTO THE FLAT ROOF
02:25 Tools required:
• Medium pile paint roller and pole
• Broom
• Safety goggles
• Stirrer
• Mini paint roller
• Craft knife
02:39 Materials required:
• One Piece EPDM Membrane
• Water-Based Deck Adhesive
• Contact Bonding Adhesive
02:49 Steps 1 to 16
06:22 WEATHERING WALL TERMINATIONS
06:26 Tools required:
• Craft knife
• Tape measure
• Scribe
• Scissors
• Paint brush
• Silicone roller
• Penny roller
• Sealant gun
06:43 Materials required:
• 9 Inch Uncured Flashing Tape
• EPDM Primer
• Lap Edge Sealant
06:52 Steps 1 to 8
08:10 INSTALLING ROOF EDGE GUTTER TRIM
08:14 Tools required:
• Hammer
• Ringshank nails
• Mini paint roller
• PolyTop nails
08:26 Materials required:
• Lengths of Gutter Trim
• Contact Bonding Adhesive
08:34 Steps 1 to 6
09:29 INSTALLING ROOF EDGE RAISED KERB TRIM
09:34 Tools required:
• Fine tooth hand saw or multi cutter
• Hammer
• PolyTop nails
09:45 Materials required:
• Lengths of Raised Kerb Trim
09:51 Steps 1 to 7
10:40 INSTALLING ROOF EDGE CORNERS
10:45 Tools required:
• Craft knife
10:51 Materials required:
• Raised Kerb Trim External Corners
• Superglue
• Superglue activator
10:58 Steps 1 to 6
Things to be aware of:
• The prepared roof surface must be clean, dry, and free from dust and contaminants (bitumen, oil, etc).
• Always countersink the screw holes in the roof deck, and sand the joins, to create a flat surface to apply the One Piece EPDM membrane to. Your EPDM flat roofs will be smooth and smart!• If there are any factory or transit creases in the One Piece membrane, carefully use a heat gun to remove them.
• Always check Contact Bonding Adhesive is touch dry before applying the membrane. This will prevent any gas bubbles from forming underneath.
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке: