HOW TO INSTALL A FLEECE BACKED EPDM ROOF - FLEXIPROOF®

🚀 New and improved version available! Watch here:    • HOW TO INSTALL A FLEECE BACKED EPDM ROOF -...  

In this video tutorial, you’ll learn how to prepare your project site and correctly install a complete, simple EPDM flat roof with the FlexiProof Fleece Backed EPDM flat roof system.

Be sure to use the right tools, materials, and techniques for the very best results on your EPDM roofing projects.

Contact us with questions or to learn more about our EPDM roofing training: https://www.flexiproof.co.uk/the-epdm...

Learn more about the FlexiProof EPDM flat roof system: https://www.flexiproof.co.uk

ROOF SURFACE PREPARATION

Tools required:
• Cordless drill with countersink
• Countersunk screws
• Belt sander
• Leaf blower

No materials required

MARK THE ROOF PERIMETER AND MEMBRANE FOR CONTACT BONDING ADHESIVE APPLICATION

Tools required:
• Combination square
• Marker pen
• Heat gun
• Scribe

Materials required:

• Fleece Backed EPDM Membrane
• Contact Bonding Adhesive

INSTALLING THE FLEECE BACKED MEMBRANE

Tools required:
• Medium pile paint roller and pole
• Broom
• Craft knife
• Pencil
• Spirit level
• Paint brush
• Silicone roller
• Hammer
• Ringshank nails

Materials required:
• Water-Based Deck Adhesive for Fleece Backed EPDM
• EPDM Primer
• Contact Bonding Adhesive
• Lengths of Gutter Trim

WEATHERING WALL TERMINATIONS

Tools required:
• Craft knife
• Scribe
• Scissors
• Paint brush
• Silicone roller
• Penny roller
• Sealant gun

Materials required:
• 9 Inch Uncured Flashing Tape
• EPDM Primer
• Lap Edge Sealant

INSTALLING ROOF EDGE GUTTER TRIM

Tools required:
• Hammer
• PolyTop nails
• Fixing pins

Materials required:
• Lengths of Gutter Trim

INSTALLING ROOF EDGE RAISED KERB TRIM

Tools required:
• Fine tooth hand saw or multi cutter
• Hammer
• Polytop nails
• Fixing pins

Materials required:
• Lengths of Raised Kerb Trim

INSTALLING ROOF EDGE CORNERS

Tools required:
• Craft knife

Materials required:
• Raised Kerb Trim External Corners
• Superglue
• Superglue activator

Things to be aware of:
• The prepared roof surface must be clean, dry, and free from dust and contaminants (bitumen, oil, etc).
• Always countersink the screw holes in the roof deck, and sand the joins, to create a flat surface to apply the One Piece EPDM membrane to. Your EPDM flat roofs will be smooth and smart!• Firmly press the membrane into 90 degree angle changes. This will avoid the membrane pulling-away, known as 'tenting', as you lift it up and onto wall upstands.
• Always check Contact Bonding Adhesive is touch dry before applying the membrane. This will prevent any gas bubbles from forming underneath.